FIBARO Switch 2 is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. FIBARO Switch 2 allows to control connected devices either via the Z-Wave+ network or via a switch connected directly to it and is equipped with active power and energy consumption metering functionality.

With the AEOTEC Nano Switch all switchable and non-dimmable electric installations (e.g. lighting, sockets...) can be integrated into a Z-Wave network. Thus, the connected load can be switched both wirelessly via Z-Wave and locally via existing wall switch. Additionally, the ZW116 has an integrated power metering function which allows to detect the exact energy consumption of the connected load.

The compact radio module (60% smaller than its predecessor Micro Smart Switch) is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the AEOTEC insert that is controlling the load. The switch only sends control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.

With the AEOTEC Dual Nano Switch all switchable and non-dimmable electric installations (e.g. lighting, sockets...) can be integrated into a Z-Wave network. Thus, the connected load can be switched both wirelessly via Z-Wave and locally via existing wall switch.

The compact radio module (60% smaller than its predecessor Micro Smart Switch) is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the AEOTEC insert that is controlling the load. The switch only sends control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.

Additionally, the ZW132 has an integrated power metering function which allows to detect the exact energy consumption of the connected load.

With the Aeotec NanoMote you control devices and scenes in your intelligent home easily and intuitively - on the wall and in your hand - with one or four buttons.

The NanoMote Quad from Aeotec is a stationary 4-button wall switch as well as a portable remote control, which can be integrated into an existing Z-Wave network as a secondary controller for wireless control of devices and scenes.

The Aeotec NanoMote sends commands to the Z-Wave gateway and controls electronic devices, shutters and blinds or lamps. The Aeotec NanoMote Quad controls up to 15 automated scenes.


The battery-operated device can be wall mounted or used as a portable remote control. It can also be used as a pendant on your key ring or car key. In order to avoid unintentional triggering, the Aeotec NanoMote has a locking function which is triggered by a predefined combination of keystrokes.